Ripv1 MCQs

10 MCQs  — Computer Networks MCQs

Practice Ripv1 MCQs with correct answers and explanations. These questions are from the Computer Networks MCQs section.

Which command displays RIP routing updates?
A. Show ip route
B. Debug ip rip
C. Show protocols
D. Debug ip route
How often does a RIPv1 router broadcast its routing table by default?
A. Every 30 seconds
B. Every 60 seconds
C. Every 90 seconds
D. Ripv1 does not broadcast periodically
Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?
A. The updated information will be added to the existing routing table debug ip rip
B. The update will be ignored and no further action will occur debug ip route
C. The updated information will replace the existing routing table entry
D. And always chooses the route with the lowest ad. however, if two routes are received and they both have the same ad, then the router will choose the one route with the lowest metrics, or in rip’s case, hop count.
You type debug IP rip on your router console and see that 172.16.10.0 is being advertised to you with a metric of 16. What does this mean?
A. The route is 16 hops away debug ip rip
B. The route has a delay of 16 microseconds debug ip route
C. The route is inaccessible
D. The route is queued at 16 messages a second
Which statement is true regarding classless routing protocol?
A. The use of discontinuous networks is not allowed
B. Use of variable length subnet masks is permitted
C. Ripv1 is a claSSLess routing protocol
D. Igrp supports classes routing within the same autonomous system
Where should we use default routing?
A. On stub networks- which have only one exit path out of the network
B. Which have more than one exit path out of the network
C. Minimum five exit paths out of the network
D. Maximum five exit paths out of the network