You want to enable both arpa and snap encapsulation on one router interface. How do you do this?

A. The interface can handle multiple encapsulation types with no extra configuration
B. Assign two network numbers, one for each encapsulation type
C. Enable novell-ether to run multiple encapsulation types
D. Both arpa and snap are enabled by default so you don’t have to configure anything

What does the “IPX maximum-paths 2” command accomplish?

A. It enables load sharing on 2 paths if the paths are equal metric paths
B. It sets up routing to go to network 2
C. It is the default for cisco ipx load sharing
D. It enables load sharing on 2 paths if the paths are unequal metric paths

As a system administrator, you need to set up one Ethernet interface on the Cisco router to allow for both sap and Novell-ether encapsulations. Which set of commands will accomplish this?

A. Interface ethernet 0.1 ipx encapsulation novell-ether ipx network 9e interface ethernet 0.2 ipx network 6c
B. Interface ethernet 0 ipx encapsulation novell-ether ipx network 9e interface ethernet 0 ipx encapsulation sap ipx network 6c
C. Interface ethernet 0.1 ipx encapsulation novell-ether interface ethernet 0.2 ipx encapsulation sap
D. Interface ethernet 0.1ipx encapsulation novell-ether ipx network 9e interface ethernet 0.2 ipx encapsulation sap ipx network 6c

The “IPX delay number” command will allow an administrator to change the default settings. What are the default settings?

A. For LAN interfaces, one tick; for WAN interfaces, six ticks
B. For LAN interfaces, six ticks; for WAN interfaces, one tick
C. For LAN interfaces, zero ticks; for WAN interfaces, five ticks
D. For LAN interfaces, five ticks; for WAN interfaces, zero ticks

What does the following series of commands “Router IGRP 71 network” accomplish? 10.0.0.0 router IGRP 109 network 172.68.7.0

A. It isolates networks 10.0.0.0 and 172.68.7.0
B. It loads igrp for networks 109 and 71
C. It disables rip
D. It disables all routing protocols

As a system administrator, you want to debug IGRP but are worried that the “debug IP IGRP transaction” command will flood the console. What is the command that you should use?

A. Debug ip igrp event
B. Debug ip igrp-events
C. Debug ip igrp summary
D. Debug ip igrp events

Which NetWare protocol provides link-state routing?

A. Nlsp
B. Rip
C. Sap
D. Ncp

Which NetWare protocol works on layer 3–network layer—of the OSI model?

A. Ipx
B. Ncp
C. Spx
D. Netbios

NetWare IPX addressing uses a network number and a node number. Which statement is not true?

A. The network address is administratively assigned and can be up to 16 hexadecimal digits long
B. The node address is always administratively assigned
C. The node address is usually the mac address
D. If the mac address is used as the node address, then ipx eliminates the use of arp

Consider a situation in which you are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem?

A. Netware 4.11 defaults to 802.2 encapsulation
B. Netware 4.11 Defaults To 802.3 Encapsulation
C. Cisco routers only work with netware 3.11
D. Netware 3.11 defaults to 802.2 encapsulation