Mechanical Engineering Mcqs — Test 8
Page 1 of 3
Question 1
The flow rate in gear pump___________________?
Question 2
Reaction turbines are used for____________________?
Question 3
The angle of taper on draft tube is A. greater than 15° B. greater than 8° C. greater than 5° D. less than 8° E. less than 3°.___________________? The angle of taper on draft tube is
Question 4
In axial flow fans and turbines, fluid enters and leaves as follows________________?
Question 5
Air vessels in reciprocating pump are used to__________________?
Question 6
According to fan laws, at constant speed and capacity, the pressure and power vary_____________________?
Question 7
Maximum impulse will be developed in hydraulic ram when ___________________?
Question 8
A hydraulic intensifier normally consists of __________________?
Question 9
Hydraulic accumulator is used for____________________?
Question 10
Puck up the wrong statement about centrifugal pump_______________?