Medical MCQs

A. Adhesion of resin particles
B. Bonding between filler crystals
C. Bonding between filler and resin
D. Bonding between tooth and resin

A. Compression moulding technique
B. Injection moulding technique
C. Fluid resin technique
D. Light cured technique

A. 30 seconds
B. 60 seconds
C. 90 seconds
D. 120 seconds

A. Cold water
B. Hot water
C. Under pressure
D. In vaccum

A. Tegdma
B. Bis-gma
C. Ti02
D. None of the above

A. Only hydrophobic component
B. Only hydrophilic component
C. Hydrophobic and hydrophilic component
D. Lyophillic and lyophobic component

A. It can be finished smoothly
B. It has a low degree of flow
C. It’s non-irritation to pulp
D. It’s wear resistant is high

A. Polymerization shrinkage is greater if bonded surface area is lesser than unbounded surface area
B. Polymerization shrinkage is high if within the enamel margins
C. Acid etching and priming will decrease polymerization shrinkage
D. Microleakage can occur because of polymerization shrinkage

A. Increasing the mechanical strength
B. Decreasing the coefficient of thermal expansion
C. Reducing the polymerization shrinkage
D. All of the above

A. Increases vertical dimension
B. Causes teeth to be shrunken in investment
C. Causes poor quality of colour
D. Causes fracture of denture