Computer Programming MCQs

5739 MCQs  (Page 288 of 574)

To measure a resistance with the help of a potentiometer it is_________________?
A. Necessary to standardise the potentiometer
B. Not necessary to standardise the potentiometer
C. Necessary to use a volt ratio box in conjunction with the potentiometer
D. None of the above
Which of the following devices should be used for accurate measurement of low D.C. voltage ?
A. Small range moving coil voltmeter
B. D.c. potentiometer
C. Small range thermocouple voltmeter
D. None of the above
A direct current can be measured by________________?
A. A d.c. potentiometer directly
B. A d.c. potentiometer in conjunction with a standard resistance
C. A d.c. potentiometer in conjunction with a volt ratio box
D. None of the above
In order to achieve high accuracy, the slide wire of a potentiometer should be_______________?
A. As long as possible
B. As short as possible
C. Neither too small not too large
D. Very thick
For measuring a very high resistance we should use_______________?
A. Kelvin’s double bridge
B. Wheat stone bridge
C. Meggar
D. None of the above
The adjustment of position of shading bands, in an energy meter is done to provide______________?
A. Friction compensation
B. Creep compensation
C. Braking torque
D. None of the above
The pressure coil of a wattmeter should be connected on the supply side of the current coil when______________?
A. Load impedance is high
B. Load impedance is low
C. Supply voltage is low
D. None of the above
For measuring current at high frequency we should use_______________?
A. Moving iron instrument
B. Electrostatic instrument
C. Thermocouple instrument
D. None of the above